Xerox Document Workstation with PlotWorks Support & Software User Guide
8-18 • PlotWorks User Guide
•
Windows and Generic Embedded Controller Printer Options: The
following two options are used with Windows and Generic Embedded
Controller printers and the 2230 and 2240 InkJet printers
following two options are used with Windows and Generic Embedded
Controller printers and the 2230 and 2240 InkJet printers
•
Printer Name: Select your printer from this drop down list.
•
Output quality: Select a value from 0 to 1200 dpi for each output
quality type. Refer to your printer manual for recommended values.
Set the desired level for each image in the Job Editor. See “The
Bottom edge option is useful when you plan to collate or fold
scanned images and you want to make sure they all face the same
direction. For example, the Bay folder requires the title block to
enter the folder last in order to get a properly folded package. Other
folders require the title block to enter the folder first.” on page 4-24.
quality type. Refer to your printer manual for recommended values.
Set the desired level for each image in the Job Editor. See “The
Bottom edge option is useful when you plan to collate or fold
scanned images and you want to make sure they all face the same
direction. For example, the Bay folder requires the title block to
enter the folder last in order to get a properly folded package. Other
folders require the title block to enter the folder first.” on page 4-24.
If Output Quality is set at a higher DPI than supported by the printer, a larger or
smaller print than desired may result.
smaller print than desired may result.
•
Minimum Paper Length: Enter a value for the minimum paper length
to use. This helps to avoid paper jams when folding.
to use. This helps to avoid paper jams when folding.
•
Hardware port number: Enter the port number on the Scorpion or
Gecko controller card that the printer is connected to (usually 1).
Gecko controller card that the printer is connected to (usually 1).
4.
Click OK.
Generic Embedded Controller Options
The Generic Embedded Controller Options dialog box is used to communicate
which roll to use for each image. Depending on your printer all or some of these
fields may be disabled.
The following fields appear on the Embedded Controller Options dialog box:
•
Header: Contains printer Opcodes and Instructions that are sent to the printer
before the image is printed.
before the image is printed.
•
Rolls 1-6: These fields function as the ‘Print Roll Specific Command’ to
determine when to switch rolls. Specify the sizes and types of media using
Media Change and set the printer Opcodes/Instructions for the roll here. The
Printer Interface will select the roll and send the necessary printer Opcodes/
Instruction to the embedded controller.
determine when to switch rolls. Specify the sizes and types of media using
Media Change and set the printer Opcodes/Instructions for the roll here. The
Printer Interface will select the roll and send the necessary printer Opcodes/
Instruction to the embedded controller.
•
Trailer: Specify finishing options such as folding etc. in this text box. These
printer Opcodes/Instructions are sent directly to the printer after the image is
printed.
printer Opcodes/Instructions are sent directly to the printer after the image is
printed.