Xerox Document Workstation with PlotWorks Support & Software User Guide

Chapter 11-20 • PlotWorks User Guide

Folding options are selected from either the Finishing Options tabbed dialog box 
or the Folding Options dialog box of the Job Editor or Client. Both dialog boxes 
offer the same folding options.

•

The Folding Options dialog box is accessed by clicking on the Output 
button and then on the Folding Options button. 

•

The Finishing Options tabbed dialog box is accessed by clicking on the 
Setup menu, then Preferences, then on the Finishing Options tab. 

How folding options are specified depends upon your folder. Instructions for 
specifying folding options for each folder follow.

This section explains how to select folding options for all folders except the MAX 
200 and GFI Folders. If you are using the MAX 200 or GFI folding options ignore 
this section. 

When selecting folding options for all folders except the MAX 200 and GFI 
Folders it is often necessary to use Finishing Macros. In this section we will first 
discuss Finishing Macros, then how to select general folding options, and then 
miscellaneous information about specific folders.

Finishing macros are not used with the MAX 200 or GFI Folders. Finishing 
macros are used with other folders to simplify the process of sending special 
commands to the printer and/or folder. Not all macros are supported for all folders. 
The following table provides information about each macro:

1

Forces use of the 1st fold card 
Forces use of belt 1

8845
Océ 9800

2

Forces use of 2nd fold card 
Forces use of belt 2

8845
Océ 9800

A

Compensation fold first. You must 
enable Margins.

3150, 2150*