Xerox 4213 MICR MRP Leaflet
LJ SERIES 2D EMULATION
Job control commands
The job control commands affect an entire print job.
Printer Reset
Purpose
The Printer Reset command restores the printer to its default
settings. This command deletes any temporary fonts and macros
from memory and prints any data remaining in the printer buffer.
It is recommended to use the Printer Reset command at the
beginning of each job.
settings. This command deletes any temporary fonts and macros
from memory and prints any data remaining in the printer buffer.
It is recommended to use the Printer Reset command at the
beginning of each job.
Syntax
E
E
Hex
1B 45
Dec
27 69
Number of Copies
Purpose
The Number of Copies command causes the 4213 to print a
specified number of copies for each page of data received until
either the number of copies is changed or a Printer Reset
command is issued. This command can be issued anywhere
within a page and acts on the current page and all subsequent
pages.
specified number of copies for each page of data received until
either the number of copies is changed or a Printer Reset
command is issued. This command can be issued anywhere
within a page and acts on the current page and all subsequent
pages.
Syntax
E
&l#X
where
#
is the number of copies to print between 1 and 99.
Example
To select 10 copies of a single page of document, enter:
E
&l10X
Hex
1B 26 6C 31 30 58
Dec
27 38 108 49 48 88
3-14
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE