Xerox 4215 MICR MRP Installation Guide

Page of 172
ENABLING IPDS
Setting up the printer for IPDS
This section contains the following procedures:
Setting the printer emulation and address for IPDS
processing only. 
Setting the printer for dual emulation and addresses in a
twinax environment if you want to process both IPDS and
SCS data streams on the same twinax printer. 
Copying the MakeITDS utility files to a directory on your
computer.
N
Note:  If you have installed the IPDS card in the coax
environment, you can skip to the “Copying the MakeITDS
utility files” section to install the MakeITDS files.  Then
continue with the “Configuring your printer” section if you
need to change any settings in the configuration file.
Configuring your printer’s IPDS interface card to change the
default font set and emulation from 4028 to 3812/3816.
N
Note:  If you have installed the IPDS option on a 4219/MRP or a
4215/MRP, you must make sure the PCL Line Wrap option is
turned off at the user interface.  Refer to your printer’s operator
guide for the procedure.
Setting the printer emulation and address for IPDS processing in twinax only
If you are working in a twinax environment, you can set the
twinax interface to respond only as an IPDS printer.  This
procedure may have been completed by your service
representative during the installation of the IPDS card.  This
section provides the steps if you need to complete the process.
N
Note:  Perform the steps in this section if you want to set up
your printer to process IPDS only. 
On the twinax interface card, use the address switch and the
TEST button to set the printer emulation and printer address.  
Figure 2–1 shows the location of the address switch, SYNC LED,
and TEST button on the twinax interface card.
Figure 2–1.
Twinax interface card 
2-2
XEROX MRP FAMILY INTELLIGENT PRINTER DATA STREAM (IPDS)
CONFIGURATION AND REFERENCE GUIDE