Xerox 4215 MICR MRP Installation Guide
PREINSTALLATION
Coax interface configurations
Use the information in this section to complete the “Coax
interface default settings” section of Checklist 2: Twinax and
Coax interface configuration.
interface default settings” section of Checklist 2: Twinax and
Coax interface configuration.
Do not attempt to change the printer’s interface hardware
configuration after installation.
configuration after installation.
Unlike the twinax environment, the coaxial default printer
language and default printer emulation can only be set through
the Function Selection via Line (FSL) commands. Refer to the
Xerox Coax Command Reference for further information on FSL
commands.
language and default printer emulation can only be set through
the Function Selection via Line (FSL) commands. Refer to the
Xerox Coax Command Reference for further information on FSL
commands.
Page size
The default page size is set by your Xerox service representative.
Your choices are:
Your choices are:
•
U.S. (8.5x11 inches)
•
A4 (8.27x11.69 inches).
Twinax interface configurations
The twinax interface card requires four default configuration
settings:
settings:
•
Printer emulation
•
Printer language
•
Page size
•
Device address.
Each of these settings is described below.
Use the information in this section to complete the “Twinax
4219/MRP 4215/MRP interface default settings” section of
Checklist 2: Twinax and Coax interface configuration in the
“Checklists” appendix.
4219/MRP 4215/MRP interface default settings” section of
Checklist 2: Twinax and Coax interface configuration in the
“Checklists” appendix.
N
Note: The printer emulation, printer language, and page size
settings described in this section can also be set through FSL
commands. Refer to the Twinax Command Reference for further
information.
settings described in this section can also be set through FSL
commands. Refer to the Twinax Command Reference for further
information.
3-4
XEROX 4219/MRP AND 4215/MRP INSTALLATION PLANNING GUIDE