Xerox 4215 MICR MRP Administrator's Guide
<
cut top 2"
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
5-41
MAINTENANCE
This section gives you procedures to maintain
your printer for optimum printer performance.
your printer for optimum printer performance.
Fuser Replacement
For optimum quality and to maintain warranty
requirements, replace the fuser after every
200,000 pages of printing. Page count can be
determined from the Start Page on the Hardware
Status Report. To print the Hardware Status
Report, follow the procedures in the “Hardware
Status Report” section found in Chapter 4.
requirements, replace the fuser after every
200,000 pages of printing. Page count can be
determined from the Start Page on the Hardware
Status Report. To print the Hardware Status
Report, follow the procedures in the “Hardware
Status Report” section found in Chapter 4.
WARNING: Always power off and unplug
the printer before beginning service
the printer before beginning service
B
WARNING: The fuser area can be very
hot. Power off the printer for a
minimum of 30 minutes before the fuser
hot. Power off the printer for a
minimum of 30 minutes before the fuser
B
Before an Extended Shutdown
When you will not be using the printer for more
than one week, do the following:
than one week, do the following:
1. Switch the printer off at the power switch.
2. Unplug the power cord.
3. Remove the paper trays and store them in a
place that is less susceptible to moisture
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer