Xerox 4215 MICR MRP Administrator's Guide

Page of 364
<
cut top 2"
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
3-10
Configuring the Interface Card
Step 6.
After the printer powers up, the green test
light flashes two times.  Wait ten seconds
after the green light flashes and release the
test button.
The Start Page (see Figure 1-26) prints (if
enabled), followed by a page with the following
single line item:
CURRENT EMULATION IS 5256
The printer emulation is now stored in
nonvolatile memory.
Printer Address
 At this point the printer
emulation is set, but the printer address is
not.  In the second part of the process you set
Step 9.
Connect the twinaxial printer cable.
Step 10.
Switch the printer on again.
The Start Page (see Figure 1-26) prints (if
enabled), followed by the Twinax Configuration
Report.
Step 11.
Verify that the printer address has been set
correctly by checking the Line Set Up field on
the Twinax Configuration Report.  For this
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer