Xerox Phaser 7500 User Guide
Safety
Phaser 7500 Color Printer
User Guide
User Guide
10
Electrical Safety
Warning:
Do not push objects (including paper clips or staples) into slots or openings on the
printer. Making contact with a voltage point or shorting out a part could result in fire or electrical
shock.
shock.
Warning:
Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are specifically instructed to do so. Power should be OFF when
performing these installations. Disconnect the power cord when removing covers and guards for
installing optional equipment. Except for user-installable options, there are no parts that you can
maintain or service behind these covers.
performing these installations. Disconnect the power cord when removing covers and guards for
installing optional equipment. Except for user-installable options, there are no parts that you can
maintain or service behind these covers.
The following are hazards to your safety:
•
The power cord is damaged or frayed.
•
Liquid is spilled into the printer.
•
The printer is exposed to water.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Power Cord
•
Use the power cord supplied with your printer.
•
Plug the power cord directly into a properly grounded electrical outlet. Make sure each end of the
cord is securely connected. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
cord is securely connected. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
•
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
a ground connection terminal.
Warning:
Avoid the potential of electrical shock by ensuring that the printer is properly grounded.
Electrical printers may be hazardous if misused.
•
Do not use an extension cord, power strip, or surge protector.
•
Verify that the printer is plugged into an outlet that is capable of providing the correct voltage and
power. Review the printer’s electrical specification with an electrician if necessary.
power. Review the printer’s electrical specification with an electrician if necessary.
•
Do not place the printer in an area where people might step on the power cord.
•
Do not place objects on the power cord.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is necessary
to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.
to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.