Xerox Phaser EX7750 Installation Guide

When you perform network Setup, you configure the EX7750 to receive print jobs 
over the network systems that are used at your site. 

If the EX7750 is configured to enable more than one protocol, it automatically 
switches to the correct protocol when it receives a print job. 

The available network types, and the Setup areas that pertain to them, are summarized 
in the following table. 

In the Setup menu, choose Network Setup, where you specify network addresses and 
names to be used by workstations, servers, and the EX7750 when they communicate 
with each other.

The Network Setup menu includes three submenus that allow you to choose port 
types, protocols, and network services. You must perform Port Setup and enable at 
least one port.

For each item you enable, you are prompted to enter settings for that item. 
Default values, where applicable, appear in this manual with square brackets.

You should display and select options only for the network systems that are currently 
used at your site. If your network requirements change, you can change Network 
Setup at any time. 

AppleTalk over Ethernet

Ethernet Setup

AppleTalk Setup

AppleTalk printing (PAP) is 
enabled automatically. 

TCP/IP over Ethernet

Ethernet Setup

TCP/IP Setup: Ethernet Setup

LPD Setup
Web Services Setup
Windows Setup
Port 9100 Setup 
IPP Setup 

IPX/SPX over Ethernet

Ethernet Setup

IPX/SPX Setup

PServer Setup (NDS, Bindery, 
or both)