Xerox Phaser EX7750 Installation Guide
2
2-15
EX7750 on a NetWare network with NDPS
Tips for experts—NetWare networks
Setting up the EX7750 in an NDPS environment is similar to setting up any other
PostScript printer on the network. When setting up the EX7750 in such an
environment, refer to the following information:
PostScript printer on the network. When setting up the EX7750 in such an
environment, refer to the following information:
•
Make sure you have a valid IP address for the EX7750 and for any workstations that
will print to it or run Fiery utilities.
will print to it or run Fiery utilities.
•
In EX7750 Setup, enable TCP/IP and enter the IP address, subnet mask, and gateway
address for the EX7750. You can enter these manually or use DHCP or BOOT protocols
to assign the addresses dynamically.
address for the EX7750. You can enter these manually or use DHCP or BOOT protocols
to assign the addresses dynamically.
•
Bidirectional communication features in NDPS are not supported on the EX7750.
Configuring a NetWare server for printing with NDPS
To configure a NetWare server for printing with NDPS, NDPS must be installed
during NetWare 5.x or later installation, and while a Broker is running on the server.
Unless you have manually unloaded the Broker, it loads and runs when you install
NDPS. Make sure you are using the latest NetWare service pack and Novell gateway.
Finally, create an NDPS Manager. For more information, see your NetWare
documentation.
during NetWare 5.x or later installation, and while a Broker is running on the server.
Unless you have manually unloaded the Broker, it loads and runs when you install
NDPS. Make sure you are using the latest NetWare service pack and Novell gateway.
Finally, create an NDPS Manager. For more information, see your NetWare
documentation.
In EX7750 Setup, make sure you have enabled TCP/IP (see
EX7750. Ping the EX7750 (see
on page 2-18) to verify that
TCP/IP communication is successful.