Xerox Phaser EX7750 Installation Guide

Network Setup

Port Setup

To configure the EX7750, choose the port type you use and enter the settings for 
that port. Since network setups are nested, the names of higher-level menus are 
shown in this chapter to the left of each menu heading.

Select Yes if you have Ethernet cabling connected to the EX7750.

Select an appropriate setting according to the settings of the network to which the 
EX7750 is connected.

When you select Auto Detect, make sure that the auto-negotiation settings 

for speed and duplex are configured for the network port to which the EX7750 is 
connected. Similarly, when you select a different setting such as 100 Mbps 
Full-Duplex, make sure the same settings are configured for the network port. 

The 1 Gbps (gigabit per second) setting is full-duplex.

To configure the EX7750, choose each protocol and enter the settings for that 
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication 
simultaneously.

Network Setup

Protocol Setup

Select Yes if you have an AppleTalk network connected to the EX7750. This setting 
enables the EX7750 to communicate over AppleTalk networks.