Xerox Phaser 4622 User Guide
Setups
Xerox Phaser 4622
User Guide
User Guide
80
Setup
The Setup options enable you to customize network settings, printer settings, general settings and
machine settings which are specific to the machine, such as Date & Time and Power Management.
machine settings which are specific to the machine, such as Date & Time and Power Management.
Network Settings
You may set up the network using the machine's display screen. Before doing that, you must have the
relevant information concerning the type of network protocols and computer system you use. If you
are not sure which setting to use, contact your System Administrator or refer to the
relevant information concerning the type of network protocols and computer system you use. If you
are not sure which setting to use, contact your System Administrator or refer to the
System
Administrator Guide
for instructions.
1.
Press the Menu button on the control panel.
2.
Press the up/down arrows to highlight Tools and press OK.
Note
If a password is required, refer to
on page 78 for instructions.
3.
Press the up/down arrows to highlight Setup and press OK.
4.
Press the up/down arrows to highlight Network Settings and press OK.
The following Network Settings options and settings are available:
5.
Press the up/down arrows to highlight the option required and press OK.
6.
Press the up/down arrows to highlight the setting required and press OK to save the selection.
Option
Description
TCP/IP v4
TCP/IPv6
Select appropriate protocol and configure
parameters to use the network environment.
parameters to use the network environment.
Network Services
Use to enable 802.1x and CentreWare Internet
Services.
Services.
Ethernet Speed
Configure the network transmission speed.
Network Ping Test
Ping is a computer network administration utility
used to test whether a particular host is reachable
across an Internet Protocol (IP) network and to
measure the round-trip time for packets sent from
the local host to a destination computer, including
the local host's own interfaces.
used to test whether a particular host is reachable
across an Internet Protocol (IP) network and to
measure the round-trip time for packets sent from
the local host to a destination computer, including
the local host's own interfaces.
AppleTalk
Use to enable the machine to be setup on an
AppleTalk network.
AppleTalk network.
NetWare
Use to enable the machine to be setup on a
NetWare network.
NetWare network.
Wireless
Use to enable the machine to be configured on a
wireless network connection.
wireless network connection.
Reset to Network Setup defaults
Reverts the network settings to the default values.