Xerox Phaser 780 Tabloid Installation Guide
Connecting Your Printer to a Network
2
Setup Guide
9
PhaserShare Series B Token Ring card
The PhaserShare Series B Token Ring port conforms to the IEEE 802.5 standard.
With the PhaserShare Series B Token Ring card, you can connect the printer
directly to a Token Ring network using shielded twisted pair (STP; IBM Type 1)
or unshielded twisted pair (UTP; IBM Type 3) cables. Contact your dealer to
obtain adapters and cables.
With the PhaserShare Series B Token Ring card, you can connect the printer
directly to a Token Ring network using shielded twisted pair (STP; IBM Type 1)
or unshielded twisted pair (UTP; IBM Type 3) cables. Contact your dealer to
obtain adapters and cables.
N
O
T
E
To fully comply with EMI specifications, the use of shielded or screened cables
may be required. “Shielded” describes IBM-defined cables used with the DB-9
connector. “Screened” describes cables that are electrically similar to Category
4 UTP, but with an added shield or screen.
may be required. “Shielded” describes IBM-defined cables used with the DB-9
connector. “Screened” describes cables that are electrically similar to Category
4 UTP, but with an added shield or screen.
When a PhaserShare Series B card is purchased initially with the printer, it is
installed at the factory. When a PhaserShare Series B card is purchased later as
an upgrade kit, follow the installation instructions that are shipped with the
card.
installed at the factory. When a PhaserShare Series B card is purchased later as
an upgrade kit, follow the installation instructions that are shipped with the
card.
When a PhaserShare Series B Token Ring card is installed in the printer, the
printer’s built-in Ethernet connector is disabled.
printer’s built-in Ethernet connector is disabled.
C
A
U
T
I
O
N
To avoid damaging the network interface, turn off the printer before making any
Token Ring connections.
Token Ring connections.