Xerox Phaser 790 Leaflet

Repacking the printer for shipping

The following procedures are intended for the safe commercial shipment of the Phaser 790 printer. The 

original packaging is safe for repackaging the printer for up to three commercial shipments. Any 

additional shipments require a new Repackaging Kit, part number 065-0595-00.

The repacking kit includes the following:

■

Instructions for repacking the printer for either a local move or for shipping by commercial carrier

■

Shipping box, cushions and pallet

■

Accessory boxes

■

Developer block

Remember to save all your printer packaging materials for safe reshipment and performance of your 

printer.

Failure to perform these steps in proper sequence could result in damage to the Phaser 790 

printer. Do not leave the printer in its shipping configuration for longer than 5 days.

Repacking the printer for a local move

To prepare the printer for local shipping, for example, in the back of a van:

Turn off the printer.

Do not remove the fuser unit, toner cartridges or imaging unit.

Carefully move the printer. Avoid hard bumps or jarring the printer. Do not tilt the printer.

The printer design is robust enough to withstand short-distance moves in the back of a van or similar 
vehicle without any special preparations. However, the imaging unit could be damaged if the printer 

receives a hard bump or shock. Unfortunately, removing the imaging unit prior to transporting the printer 

allows toner in the printer’s waste auger system to spill inside the printer during the move.