Xerox Phaser 540 Leaflet
Using manual feed
Use manual feed for printing on a media other than what is installed
in the media tray. When the printer senses media in the manual feed
tray, it picks that media. You can also select manual feed in the front
panel; when you do, the front panel reads
in the media tray. When the printer senses media in the manual feed
tray, it picks that media. You can also select manual feed in the front
panel; when you do, the front panel reads
Manual Feed: Paper
or
Manual Feed: Transparency
. The message remains in the front panel
until you feed media at the manual feed slot or make another selection.
(This front panel setting is overridden by a driver selection.) If no media is
loaded in the manual feed tray when manual feed is selected, the printer
waits 60 seconds before it picks media from a tray (the default timeout is
60 seconds).
(This front panel setting is overridden by a driver selection.) If no media is
loaded in the manual feed tray when manual feed is selected, the printer
waits 60 seconds before it picks media from a tray (the default timeout is
60 seconds).
Caution
Do not re-use media that has been fed through the printer once
(for example, after jams or if the media is ejected without being
printed). You may damage the printer.
(for example, after jams or if the media is ejected without being
printed). You may damage the printer.
Also, do not print double-sided. Although your output may
look acceptable, you may shorten the life of the imaging unit.
look acceptable, you may shorten the life of the imaging unit.