Xerox XDPE/400 (also known as EOMS I-Services) Support & Software User Guide

Use this method to specify such things as overriding specific printer 

interface commands.
You can insert XES commands directly into the data stream, before the 

banner page, by using list processing. List processing uses a resource list 

you create using the Create Xerox Resource List (CRTXRSCLST) 

command. A resource list can include the name of an XES generic packet. 

Within the generic packet, you specify a file name which references an 

ASCII file located in the XDPEFLR/GENXES subfolder.
The contents of an XES generic packet file used by list processing are 

downloaded with resources and processed before the banner page is 

processed. The specifications are used only once. 
Refer to 

 for more information on list processing.

You can insert XES commands directly into the data stream, after the 

banner page, and before the first printed page of the job, by specifying a 

generic packet in the Generic XES packet (GENXES) parameter of the 

Create XES Packet (CRTXES) command.
The contents of a generic packet specified in this manner are used either 

once for the printed job or once each page of the printed job. You indicate 

which method with the Invocation type subparameter of the GENXES 

parameter.
The effect of parameters specified here is influenced by the following:
•

The setting of the Order of sequence (SEQUENCE) Monitor Queue 

parameter

•

Logical processing specified for the job

•

A generic packet data downloaded with list processing

•

Internal XDPE/400 parameter resets

You can use generic packets in this manner when using either the Direct 

or Combined method of processing.
For more information on using the GENXES parameter, refer to “

” in this chapter.