Xerox XDPE/400 (also known as EOMS I-Services) Support & Software User Guide
Installing and Customizing XDPE/400 (9/2001)
4-1
4.
4
Installation requirements
This chapter describes the system requirements and migration issues that
need to be addressed before installing XDPE/400.
Requirements
Before you install XDPE/400, make sure that your AS/400 system and
Xerox printer configuration are ready to work with XDPE/400.
XDPE/400 runs in IBM-supported OS/400 environments. When IBM
XDPE/400 runs in IBM-supported OS/400 environments. When IBM
releases new operating system release levels, XDPE/400 will be updated
to ensure compatibility. Conversely, when IBM withdraws support for an
operating system release level, Xerox also will withdraw support of that
release level six months later. Contact your local Xerox representative or
review the bulletin accompanying your latest maintenance to verify
specific supported software release levels.
AS/400 system requirements
To install and run XPDE/400, your AS/400 system must meet these
requirements:
•
•
OS/400 version 4.4.0, 4.5.0, or 5.1. These IBM PTFs are required:
— For 4.4.0, no PTFs are required.
— For 4.5.0, apply cumulative maintenance C0231450 and PTF
SF63410.
— For 5.1, no PTFs are required.
•
Twinaxial workstation controller or TCP/IP
•
A minimum of 35 megabytes (MB) of available disk storage
•
At least one of these devices:
— CD-ROM drive
— 1/4-inch cartridge tape drive
— 8-mm cartridge tape drive
— 1/2-inch 3480 or 3490 tape drive
— 1/2-inch reel-to-reel tape drive (1600 bpi)
NOTE: XDPE/400 is distributed on CD-ROM. Other media types
are available upon request.