Xerox XDPE/400 (also known as EOMS I-Services) Support & Software User Guide
Printing Documents with XDPE/400 (9/2001)
26-15
Troubleshooting
Duplex problems on DP65 printer
If you experience duplex problems when printing to a DP65 printer and
you are using banner and/or trailer pages, make sure you have not
specified duplex or tumble duplex for the %XRXrequirements: command
in your extended job ticket packet. You can edit or display the contents of
your extended job ticket packet by using the CHGXTCK command.
The Monitor Queue automatically generates an internal job ticket that
The Monitor Queue automatically generates an internal job ticket that
contains the %XRXrequirements: command. Therefore, you do not need
to include this command in your extended job ticket packet. Refer to
” in chapter 16 for a list of internally created
job ticket commands.
Job ignores margin defined in PCL packet when printing in
*COMBINED with *ATTRIB mode
*COMBINED with *ATTRIB mode
If your job prints with the MARGIN spool file attribute instead of the
MARGIN PCL packet parameter when Monitor Queue has been started
with the ALWAYS Monitor Queue parameter set to *COMBINED and the
SEQUENCE Monitor Queue parameter set to *ATTRIB, you will need to
specify both a top margin value and a left margin value for the MARGIN
parameter in the PCL packet.
Job ignores top margin defined in PCL packet in *DIRECT
mode when printing spool files created using DDS
mode when printing spool files created using DDS
While in *DIRECT mode, if your job prints a larger margin than defined in
the PCL packet, you will need to create a generic PCL packet to adjust
the top margin for the extra carriage return/line feed commands generated
by the Host Print Transform (HPT) from the Data Description Specification
(DDS).
The PCL generic packet must contain a PCL Vertical Cursor Position
The PCL generic packet must contain a PCL Vertical Cursor Position
command with a negative value, which is the number of lines where the
margin prints, less the number of lines specified in the PCL packet Top
margin parameter.
For example, if the job prints with a margin of 8 lines and the PCL packet
For example, if the job prints with a margin of 8 lines and the PCL packet
Top margin parameter is 6 lines, you would use the value -2. The syntax
of the Vertical Cursor Position command is:
Hex ‘1B 26 61 2D 32 52’ or ASCII (Esc)&a-2R
Refer to the PCL 5 Printer Language Technical Reference Manual for
Hex ‘1B 26 61 2D 32 52’ or ASCII (Esc)&a-2R
Refer to the PCL 5 Printer Language Technical Reference Manual for
information on the implementation of PCL commands.