Xerox DocuTech 6100 Production Publisher User Guide
Solutions in Alphabetical Order
DT6180 HandyBook 123
Clear the Paper Jams in Areas 7, 6, 5, 4, and 2
NOTE: These areas should be cleared in the order given; from areas 7, 6, 5, 4, and then area 2.
To clear area 7:
1. Open the Processor Doors.
2. Just below the top of the machine, behind the left Processor Door, is a green handle with an arrow
2. Just below the top of the machine, behind the left Processor Door, is a green handle with an arrow
pointing up and to the left. Lift up and hold the green handle in this position.
3. Below the green handle is a green knob. Rotate the knob to the left and remove any paper in this
area.
NOTE: If paper falls into the machine, and cannot be retrieved, a service call will need to be
placed. This happens occasionally, but not normally.
NOTE: If paper falls into the machine, and cannot be retrieved, a service call will need to be
placed. This happens occasionally, but not normally.
4. Lower the green handle. Make sure that the area 7 baffle is lowered and latched securely.
To clear area 6:
5. Locate and pull out the Fuser Module. Grasp the square gray handle with a horizontal green stripe
and rotate it out and up at the same time. The handle is located above and to the left of Paper Tray
1.
1.
CAUTION: The Fuser is very hot!
6. Remove any paper in the Fuser area. Make sure to look at the bottom of the Fuser Module for any
trapped sheets of paper.