Xerox DocuTech 6100 Production Publisher User Guide

 
DT6180 HandyBook                                                                                                                   125 

 

19.  Lower the green handle back into position.  

NOTE: Even if paper is not visible, go through the sequence to clear the paper jam. Carefully inspect the 
rollers for any debris or torn pieces of paper. When clearing misfeeds, make sure a full sheet of paper was 
cleared and there are no pieces of paper left in the machine.  
 

 
NOTE: You will need wire cutters to perform this procedure. The wire cutters are located next to Stitcher 
Spool B.  

 

1.  Open the Finisher Doors.  
2.  Locate the Stitcher panel. The Stitcher panel is a black metal plate about 228 mm (9 inches) 

square. Lift the plate out from the bottom and then up.  

3.  Check to see if there is wire on the spool. If the spool is empty, or if the wire is tangled or trapped 

on the spool, you will need to replace Stitcher Spool A.  

4.  Pull the green Stitcher wire release handle forward and up.  
5.  Locate the Stitcher wire plug above the Binder tape drawer. The Stitcher wire plug is a long, black 

cylinder located to the left of a very large gray metal block on the Stitcher Module. A smaller white 
tube containing the stitch wire feeds into the plug.  

6.  Press down on the release clip. The release clip is a flat metal piece located directly above where 

the Stitcher wire plug plugs into the machine.  
 

 

7.  Pull the Stitcher plug out of the Stitcher head.  
8.  Using the wire cutters, slowly pull approximately 914 mm (3 feet) of wire out of the Stitcher plug.  
9.  Carefully cut the wire and make sure to leave approximately 51 mm (2 inches) of wire extending 

from the Stitcher plug.