Xerox DocuTech 6100 Production Publisher User Guide

 
DT6180 HandyBook                                                                                                                   132 

 
 
 

 
NOTE: Before you begin, you must be logged on as a System Administrator or Trusted User.  
 
If jobs are currently printing or waiting to print, you will need to place them on hold.  

1.  If you are using DocuSP software version 2.x or below, open the DocuSP Print Services window. If 

you are using DocuSP software version 3.x or above, open the DocuSP for DocuTech 2000 Series 
61xx window.  

2.  Select [System] from the toolbar. A menu will be displayed.  
3.  Select [Immediate Shutdown]. A window will be displayed with a message, 'Do you want to 

Shutdown the System?'  

4.  Select [Yes]. Within one minute the screen will turn blank and display an OK prompt.  
5. Type 

boot at the OK prompt and select [Enter].  

 

 
There are two locations for the circuit breakers that need to be checked.  
 
There are three circuit breakers located behind the small door just to the left of the two large Processor 
Doors. The breakers are toward the bottom of the panel when the door is open. 
 
There are two additional circuit breakers located on the two grey boxes on the bottom rear of the Processor. 
If the circuit breakers are switched off, power to the modules will be interrupted.  

1.  Open the right Processor Door.  
2.  Power OFF the machine using the main power button in the upper right corner. 

 

 

3.  At the rear of the Processor, there are two grey boxes toward the bottom with a set of white switch 

handles on each box. These are the circuit breakers. The circuit breakers are ON if the handles are 
up. If the white handles are down, then push up on each switch handle to reset it. 
 

 

4.  Open the Electrical Module Door which is the small door just to the left of the two large Processor