Xerox DocuTech 6100 Production Publisher User Guide
Replacing Consumables
DT6180 HandyBook
38
seal that is attached to the bottle.
7. Shake the new bottle several times to loosen the Toner.
8. Insert the bottle into the receptacle.
9. Rotate the green handle down, to the latched position.
8. Insert the bottle into the receptacle.
9. Rotate the green handle down, to the latched position.
10. Push the new bottle all the way into the machine.
11. Hold the bottle in place with your hand and pull off the protective seal.
11. Hold the bottle in place with your hand and pull off the protective seal.
12. Close the Processor Doors.
Replace the Toner (Dry Ink) Waste Container
NOTE: When the message 'Replace the Waste Container' is displayed on your machine, replace
the container as soon as possible. If the Toner (Dry Ink) Waste Container is not replaced, the
machine will eventually stop and will not run until the container is replaced.
To replace the Toner Waste Container:
1. Open the Processor Doors.
2. Locate the Toner Waste Container which is located directly under Area 6, near the floor.
3. Place a drop cloth or a few sheets of paper on the floor under the Toner Waste Container
2. Locate the Toner Waste Container which is located directly under Area 6, near the floor.
3. Place a drop cloth or a few sheets of paper on the floor under the Toner Waste Container
area to catch any Toner that may spill.
4. Grasp the tab on the Toner Waste Container and pull the container out of the machine,
slowly.