Xerox DocuTech 6100 Production Publisher User Guide

 
DT6180 HandyBook 

46  

 
NOTE: Adjusting the top edge of the Binder Tape changes the positioning of the tape. Adjusting 
the bottom of the Binder Tape changes the length of the tape.  
 
To adjust the Binder Tape registration:  

1.  Make sure that the tape guides are clean and free of glue residue. The tape guides are 

on the top of the Binder.  

2.  Measure the adjustment amount for the top edge of a finished book. If the tape is 

overhanging on the top or bottom, and not covering the bottom or top, then the tape 
position needs to be adjusted.  

3.  Open the Finisher Doors. 

 

 

 

 

4.  Locate the black Binder tape knob on the front of the Binder Drawer; just to the right of 

Paper Tray 3. You should see the Binder tape coming out from the bottom and wrapping 
around the feeder back into the Finisher. 
 

 

 
The knob is spring loaded and moves in increments to change the location of the Binder 
tape. Each increment equals a change of 0.1 mm, up or down, on the edge of the book. 
One full rotation of the knob is equal to 1 mm (0.04 inch).  

5.  Pull the knob toward you to rotate it for the adjustment.  
6.  Adjust the tape position by performing one of the following steps:  

•  Pull the knob and rotate it to the right to move the tape toward the top edge of the 

book, or  

•  Pull the knob and rotate it the left to move the tape toward the bottom edge of the