Xerox DocuTech 6100 Production Publisher User Guide
Solutions in Alphabetical Order
DT6180 HandyBook 68
Clean Finisher Entrance Sensor (Q1201)
NOTE: The Finisher Entrance Sensor (Q1201) is to the right of Area 8 along the top paper path.
1. Fold a sheet of A4 or 8.5 x 11 inch paper twice to make a 51 mm (2 inch) wide strip. This will be
used to clear the sensor.
2. Open the Processor Top Cover, above Paper Trays 1 and 2.
3. On the very right side of the opening, 127 mm to 152 mm (5 to 6 inches) back from the front of the
3. On the very right side of the opening, 127 mm to 152 mm (5 to 6 inches) back from the front of the
machine, look for a shiny black piece of plastic. The piece of plastic is approximately 38 mm (1 ½
inches) long from front to back, and 6 mm (¼ inch) wide.
inches) long from front to back, and 6 mm (¼ inch) wide.
NOTE: The sensor is as far to the right as you can see inside and has very small white lettering on
it.
4. Standing between Paper Trays 1 and 3, hold the folded part of the paper against the flat metal in
the paper path nearest you. Slide the paper to your right. The folded edge will go under the black
plastic guide that looks like a ladder. Push the paper until it stops.
plastic guide that looks like a ladder. Push the paper until it stops.
5. Slide the folded piece of paper back and forth a few times to clear any obstructions.
6. Remove the paper and close the Processor Top Cover firmly until you hear the latch click.
7. Open the Interposer Front Doors. Clear areas F, G, and H. Leave the Interposer Doors open.
7. Open the Interposer Front Doors. Clear areas F, G, and H. Leave the Interposer Doors open.
Area F:
Area G: