Xerox ColorQube 8870 Administrator's Guide
Network Administration Features
ColorQube 8570/8870 Color Printer
System Administrator Guide
System Administrator Guide
36
TCP/IP
Both IPv4 and IPv6 can be enabled or disabled independently of each other. IPv4 is enabled by
default. Changes to this setting become active after you save the changes, and then restart the printer.
default. Changes to this setting become active after you save the changes, and then restart the printer.
Note:
If you disable TCP/IP IPv4 and IPv6, you cannot access the printer using CentreWare IS. To
reset TCP/IP settings at the control panel, select Printer Setup > Connection Setup > Reset
Connection Setup.
Connection Setup.
To disable TCP/IP at the printer control panel:
1.
1.
Select Printer Setup.
2.
Select Connection Setup.
3.
Select Network Setup.
4.
Select TCP/IPv4 Setup or TCP/IPv6 Setup.
5.
Use the Down Arrow button to select IPv4 or IPv6.
6.
Press the OK button.
To change TCP/IP settings:
1.
1.
Launch a Web browser from your computer.
2.
Type your printer IP address in the browser Address field. For details, see
3.
Click Properties.
4.
On the left navigation pane, expand the Protocols folder.
5.
Select TCP/IP.
6.
If prompted, type your Admin or Key User name and password.
7.
To edit IPv4 Settings, click TCP/IP (v4) at the top of the page).
8.
To edit IPv6 Settings, click TCP/IP (v6) at the top of the page).
9.
Change settings as necessary, then click the Save Changes button.
IPv4
1.
On the TCP/IP (v4) Settings page, select TCP/IP v4 Enabled to enable IPv4.
2.
Next to Auto IP Enable select one of the following:
•
•
On: The printer attempts to assign an IP Address using the Auto IP Protocol. This protocol
enables a network device to assign an IP Address to the device when DHCP/BOOTP requests
for IP address assignment fail, and the device has no static IP address. The IP address
assigned is in the range of 169.254.1.0 to 169.254.254.255. The default setting is On.
enables a network device to assign an IP Address to the device when DHCP/BOOTP requests
for IP address assignment fail, and the device has no static IP address. The IP address
assigned is in the range of 169.254.1.0 to 169.254.254.255. The default setting is On.
•
Off: The printer does not use the Auto IP protocol to assign an IP address. This setting is
recommended for use on enterprise networks.
recommended for use on enterprise networks.
3.
Next to BOOTP/DHCP, select one of the following:
•
•
On: The printer issues BOOTP and DHCP requests on startup. The BOOTP/DHCP server assigns
the printer an address.
the printer an address.
•
Off: The printer does not issue BOOTP or DHCP requests on startup. Select this setting to
configure the printer TCP/IP settings manually.
configure the printer TCP/IP settings manually.
Note:
To use the printer with BOOTP, set up a reservation for the printer on the BOOTP server.