Xerox DocuColor 12 Printer with Fiery X12 Installation Guide
3
3-48
Performing Setup from the Control Panel
Restoring the Fiery to factory defaults
When Fiery system software is first installed, a backup copy is made automatically.
This backup includes the Fiery system software. If the Fiery Advanced Controller
Interface option was originally installed, the backup also includes the
Windows NT 4.0 operating system. You can recover from this backup if necessary
without having to reload the software from CDs.
This backup includes the Fiery system software. If the Fiery Advanced Controller
Interface option was originally installed, the backup also includes the
Windows NT 4.0 operating system. You can recover from this backup if necessary
without having to reload the software from CDs.
All job data is cleared when you restore the backup. For information about the items
that are cleared, see “Clearing the Fiery.” You must perform Setup again because the
Fiery is restored with default settings.
that are cleared, see “Clearing the Fiery.” You must perform Setup again because the
Fiery is restored with default settings.
T
O
RESTORE
THE
F
IERY
:
1.
Make sure the Fiery is at Idle.
2.
Press the Menu button and choose Shut Down.
3.
Choose Reboot System.
4.
Immediately press the first line selection button and hold it until the diagnostics have
finished.
finished.
See “Fiery Control Panel” on page 3-3 for the location of the line selection button.
During reboot, a progress bar indicates when the diagnostics have been completed.
During reboot, a progress bar indicates when the diagnostics have been completed.
5.
Choose Restore Backup.
Printing a Configuration page from the Control Panel
The Configuration page lists all the settings in effect from the current Setup. After you
have finished running Setup, print a Configuration page to confirm your settings. The
Configuration page can also be printed from the Command WorkStation. See
page 4-38 for details.
have finished running Setup, print a Configuration page to confirm your settings. The
Configuration page can also be printed from the Command WorkStation. See
page 4-38 for details.
After you make changes to Setup and choose Exit Setup, the Fiery reboots. This allows
the Fiery to recognize the new settings and display them properly on the
Configuration page. Allow the Fiery to reboot and return to Idle before printing a
Configuration page. In particular, the reboot is necessary if you specified the DHCP,
BOOTP, or RARP protocol to obtain an IP address automatically for the Fiery.
the Fiery to recognize the new settings and display them properly on the
Configuration page. Allow the Fiery to reboot and return to Idle before printing a
Configuration page. In particular, the reboot is necessary if you specified the DHCP,
BOOTP, or RARP protocol to obtain an IP address automatically for the Fiery.