Craftsman 30499 User Manual

Compatible with 315 MHz or 390 MHz 
garage door openers manufactured after 
January 1, 1993. Make sure the garage 
door opener has a working light bulb 
because it is a programming indicator.

Locate the Program button on 
the remote control

.

Program Button

Locate the Learn button on 
the garage door opener.
NOTE: Your garage door 
opener may look different.

Green or
Red/Orange

Purple

Yellow

Learn 
LED

Learn 
LED

Learn 
LED

To enter programming 
mode, press the Program
button until the LED on the
front of the remote control 

turns on.

Safety Pin or
Paper Clip

Press and release the 
Learn button on 
the garage door 
opner.

The Learn LED will light.

Within 30 seconds...

Press and release the remote 
control button you want to use...
Check to see if the garage door opener 
light bulb blinks. If not, wait for the 
remote control LED to light solid then 
slowly press and release the remote 
control button again. Repeat until the 
light bulb blinks. 
DO NOT press the button after the 
light bulb blinks.

To exit programming mode, press 
any remote control button except 
the button that was just programmed.

The garage door opener 
will activate.

To test, press the programmed button on the remote control...

The LED on your remote will 
stop flashing when the 
battery is low and needs to 
be replaced.
To replace battery, open the 
case as shown. Insert 
battery positive side up (+). 
Replace the battery with 
only 3V2032 coin cell 
batteries. Dispose of old 
battery properly.

Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  10A20

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•   ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play 

with remote controls.

•   Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no 

obstructions to door travel.

•   ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross 

path of moving gate or door.

To prevent possible SERIOUS INJURY or DEATH:
•  NEVER allow small children near batteries.
•   If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
•  Replace ONLY with 3V2032 coin batteries.
•   DO NOT recharge, disassemble, heat above 212° F 

(100° C) or incinerate.

NOTICE: To comply with FCC and or Industry 
Canada rules (IC), adjustment or modifications 
of this receiver and/or transmitter are prohibited, 
except for changing the code setting or 
replacing the battery 
THERE ARE NO OTHER USER SERVICEABLE 
PARTS.
Tested to Comply with FCC Standards for Home 
or office use. Operation is subject to the 
following two conditions: (1) this device may 
not cause harmful interference, and (2) this 
device must accept any interference received, 
including interference that may cause undesired 
operation.