Zanussi ZRG16601WA User Manual

• Any electrical work required to do the servic-

ing of the appliance should be carried out by
a qualified electrician or competent person.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare
parts must be used.

This appliance does not contain gasses
which could damage the ozone layer, in ei-

ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol 

 are recyclable.

Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a
medium setting.

To turn off the appliance, turn the Temperature
regulator to the "O" position.

The temperature is automatically regulated.
To operate the appliance, proceed as follows:

• turn the Temperature regulator toward lower

settings to obtain the minimum coldness.

• turn the Temperature regulator toward higher

settings to obtain the maximum coldness.

A medium setting is generally the most
suitable.

However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Important! If the ambient temperature is high
or the appliance is fully loaded, and the
appliance is set to the lowest temperatures, it
may run continuously causing frost to form on
the rear wall. In this case the dial must be set to
a higher temperature to allow automatic
defrosting and therefore reduced energy
consumption.

Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap so

as to remove the typical smell of a brand-new
product, then dry thoroughly.

Important! Do not use detergents or abrasive
powders, as these will damage the finish.