Bosch KGE 39 AW 25 R Sportline User Manual

Page of 70
en
7
Ambient temperature 
and ventilation
Ambient temperature
The appliance is designed for a specific 
climate class. Depending on the climate 
class, the appliance can be operated at 
the following temperatures.
The climate class can be found on 
the rating plate. Fig.
-
Note
The appliance is fully functional within 
the room temperature limits of the 
indicated climatic class. If an appliance 
of climatic class SN is operated at colder 
room temperatures, the appliance will 
not be damaged up to a temperature 
of +5 °C.
Ventilation
Fig.
3
The air on the rear panel of the 
appliance heats up. Conduction of the 
heated air must not be obstructed. 
Otherwise, the refrigerating unit must 
work harder. This increases power 
consumption. Therefore: Never cover 
or block the ventilation openings!
Connecting 
the appliance
After installing the appliance, wait at least 
1 hour until the appliance is switched on. 
During transportation the oil in the 
compressor may have flowed into the 
refrigeration system.
Before switching on the appliance for 
the first time, clean the interior of the 
appliance (see chapter “Cleaning 
the appliance”).
Electrical connection
The socket must be near the appliance 
and also freely accessible following 
installation of the appliance. 
The appliance complies with the 
protection class I. Connect the appliance 
to 220–240 V/50 Hz alternating current 
via a correctly installed socket with 
protective conductor. The socket must 
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the 
stated voltage and current type match 
the values of your mains supply match 
the values of the mains supply. This 
information can be found on the rating 
plate. Fig.
ã=
Warning
Never connect the appliance to 
electronic energy saver plugs.
Our appliances can be used with mains 
and sine-controlled inverters. Mains-
controlled inverters are used for 
photovoltaic systems which are 
connected directly to the national grid. 
Sine-controlled inverters must be used 
for isolated applications (e.g. on ships or 
in mountain lodges) which are not 
connected directly to the national grid.
Climate class
Permitted ambient 
temperature
SN
+10 °C to 32 °C
N
+16 °C to 32 °C
ST
+16 °C to 38 °C
T
+16 °C to 43 °C