AL-KO SnowLine 55 E 113 096 User Manual

Page of 198
Assembly
440829_a
17
Prior to each use, check the machine for da-
mage and have damaged parts replaced be-
fore using.
Keep  others,  especially  children  and  pets,
away from the operating area.
The  machine  operator  or  user  is  responsi-
ble for accidents involving other persons and
their property.
Children  and  persons  who  are  not  familiar
with  operation  are  not  permitted  to  use  the
snow blower.
Observe the local regulations governing the
minimum age of the operator.
Do not operate when under the influence of
alcohol, drugs or medication.
Wear appropriate work clothing.
Winter clothing
Sturdy, non-slip footwear
Eye protection (safety glasses or visor)
Hearing protection
Work only when there is adequate daylight or
artificial lighting. Adjust your speed to condi-
tions. Walk, don’t run.#
Keep hands, feet and clothing away from the
auger and impeller.
Observe  local  ordinances  regarding  opera-
ting times.
Never leave the machine unattended when it
is ready for operation.
Be  careful  when  working  on  slippery  sur-
faces.  Danger  of  slipping,  especially  when
moving in reverse.
Adjust your speed to conditions.
In the following situations, switch off the en-
gine and wait until the machine is at rest, then
disconnect the spark plug connector:
When not using the machine
During cleaning and maintenance
Before making adjustments
When malfunctions occur
Before loosening blockages
Before unclogging
After hitting obstacles
If malfunctions or unusual vibrations oc-
cur
Do not clear snow from roofs.
Do not use the machine on steep slopes due
to the risk of slipping or tipping. Exercise ad-
ditional caution when turning on sloped sur-
faces.
Never lift or carry the machine while the en-
gine is running.
Fremdkörper im Arbeitsbereich entfernen.
Use the skid plates to adjust the distance of
the  clearing  plate  from  the  surface.  Do  not
operate the machine on gravel surfaces.
Do not eat, drink or smoke while filling with
petrol or engine oil.
Do not inhale petrol fumes.
Take precautions to ensure that discharged
snow  does  not  cause  injury  to  persons  or
animals or damage to buildings, vehicles or
other objects. Make sure that traffic is not im-
paired and that drivers are not endangered.
Keep hands out of the snow discharge chute
while the machine is running.
Keep  hands  and  feet  away  from  the  auger
and impeller while the machine is running.
ASSEMBLY
CAUTION!
Do not operate the machine until it has
been fully assembled.
Initial steps
1. Remove all the parts from the packaging.
2. Check all parts for transport damage.
If  you  discover  damage  or  if  there  are
parts missing, contact the dealer where
you  purchased  the  machine  immedia-
tely.
Attaching the guide handle
see Figure. (2a /2b)
1. Place the upper handle onto the lower handle
on the outside.
2. Insert  the  screws  outwards  from  the  inside
through the guide holes.
3. Tighten on both sides using the lock nuts.
4. Fastening cable guide to the leadership bar
and putting rope traction in.
The guide handle is now attached.
Mounting the hand crank
The hand crank is used to adjust the discharge
direction.
see Figure (3a / 3b)