AL-KO SnowLine 55 E 113 096 User Manual

Operation

20

440829_a

Stopping operation
1. Letting safeguarding hangers off.

➯

Unclogging the snow discharge chute
If snow does not discharge properly, the augers

or the discharge chute may be clogged with snow

or ice.
1. Release the safety bar. (9-1, 1-2)

➯

2. Switch off the engine.
3. Disconnect the spark plug connector.
4. Carefully remove the snow from the discharge

chute and auger using the useful cleaning tool

(1-7, 1-8)

If snow still does not discharge properly, contact

a qualified workshop.

CAUTION!
risk of injury!
Before  performing  any  maintenance  or

service, always switch off the engine and

disconnect the spark plug connector.
The engine may coast down. After swit-

ching off, make sure that the engine is at

a standstill.

Clean the machine after every use. Be espe-

cially sure to remove residual de-icing salt.
Do not hose down the unit with water! Water

penetration may cause malfunctions (ignition

system, carburettor).
Replace the silencer if defective.
Follow the maintenance schedule.
Follow the instructions in the engine manual.

Maintenance schedule
After the first 5 hours of operation

Change the engine oil (see engine manual).

Before each use

Check the oil level (see engine manual).
Check the shear pins.
Check machine for damage.

After every use

Sputum  shaft,  snail,  handles  and  cases

clean.

As required

Checking clearing up plate (9-4), exchanging

abgenutze clearing up plate.

Every three months

Lubricate the snow discharge chute ring with

spray oil

1 x per season

Letting check and service equipment in a sub-

ject workshop.

Annually

Replace spark plug (see engine manual).

CAUTION!
Do not hose down the machine with wa-

ter! Water could get into the switch-plug

combination and the electric motor and

damage these.

1. Switch off the machine on solid, level and ho-

rizontal ground.

2. Remove residual road salt and dirt.

Always follow the instructions in the en-

gine operating manual provided.

If the wheel drive no longer engages when the en-

gine is running, the control cable must be adjus-

ted.

Switch off the engine before adjus-

ting the control cable.
If the wheel drive mechanism cannot

be  disengaged,  switch  off  the  en-

gine. Do not attempt repair; contact

a qualified workshop.

Drawing protection of the bowden cable fea-

ther up.
Closest to Sicherungstift into this higher put

regulation element in (X).
Stretching  protection  of  the  bowden  cable

feather to down.
Check the adjustment by starting the engine

and engaging the wheel drive.
If the wheel drive still does not engage and

disengage properly, have the machine repai-

red by a qualified workshop.