AL-KO SnowLine 560 II 112 933 User Manual
GB
Translation of original user instructions
30
AL-KO snow blower
Maintenance and care
Danger - risk of injury!
ƒ %HIRUHSHUIRUPLQJDQ\PDLQWHQDQFHRUVHUYLFH
always switch off the engine and disconnect the
spark plug connector.
spark plug connector.
ƒ 7KHHQJLQHPD\FRDVWGRZQ$IWHUVZLWFKLQJRII
PDNHVXUHWKDWWKHHQJLQHLVDWDVWDQGVWLOO
&OHDQWKHPDFKLQHDIWHUHYHU\XVH%HHVSHFLDOO\
VXUHWRUHPRYHUHVLGXDOGHLFLQJVDOW
Do not hose down the unit with water!
:DWHUSHQHWUDWLRQPD\FDXVHPDOIXQFWLRQVLJQLWLRQ
V\VWHPFDUEXUHWWRU
Replace the silencer if defective.
)ROORZWKHPDLQWHQDQFHVFKHGXOH
)ROORZWKHLQVWUXFWLRQVLQWKHHQJLQHPDQXDO
Maintenance schedule
$IWHUWKHÀUVWKRXUVRIRSHUDWLRQ
&KDQJHWKHHQJLQHRLOVHHHQJLQHPDQXDO
Before each use
Changing the wheel drive speed
1. Release (disengage) the auger and wheel drive
clutch levers (
38-1).
Change the drive speed only when disengaged
LQRUGHUWRDYRLGGDPDJLQJWKHPDFKLQH
2. Change the drive speed using the speed selector
(
38-2).
Unclogging the snow discharge chute
If snow does not discharge properly, the augers or
WKHGLVFKDUJHFKXWHPD\EHFORJJHGZLWKVQRZRULFH
1. Release (disengage) the auger and wheel drive
clutch levers (
38-1).
2. Switch off the engine.
3. Disconnect the spark plug connector.
4.
&DUHIXOO\UHPRYHWKHVQRZIURPWKHGLVFKDUJH
chute and auger using the snow cleaning tool
(
chute and auger using the snow cleaning tool
(
39-1).
If snow still does not discharge properly, contact a quali-
¿HGZRUNVKRS
Maintaining the wheel drive
Adjusting the control cable
If the wheel drive no longer engages when the engine is
UXQQLQJWKHFRQWUROFDEOHPXVWEHDGMXVWHG
Caution!
ƒ Switch off the engine before adjusting the con-
trol cable.
ƒ ,IWKHZKHHOGULYHPHFKDQLVPFDQQRWEHGLVHQ-
JDJHGVZLWFKRIIWKHHQJLQH'RQRWDWWHPSW
UHSDLUFRQWDFWDTXDOL¿HGZRUNVKRS
1. Loosen the lock nut (
41-1).
2.
7XUQWKHDGMXVWPHQWRQWKHFRQWUROFDEOHLQWKH
direction of the arrow (
direction of the arrow (
41-2) until the control
FDEOHGRHVQRWVDJLHLVVRPHZKDWWDXWZKHQ
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
3. Tighten the lock nut.
4.
&KHFNWKHDGMXVWPHQWE\VWDUWLQJWKHHQJLQHDQG
engaging the wheel drive.
engaging the wheel drive.
5. If the wheel drive still does not engage and
GLVHQJDJHSURSHUO\KDYHWKHPDFKLQHUHSDLUHG
E\DTXDOL¿HGZRUNVKRS
&KHFNWKHRLOOHYHOVHHHQJLQHPDQXDO
Check the shear pins.
&KHFNPDFKLQHIRUGDPDJH
Every three months
Check the tyre pressure.
Lubricate the snow discharge chute ring with
spray oil (
spray oil (
11).
Annually
5HSODFHVSDUNSOXJVHHHQJLQHPDQXDO
Lubricate auger.
Lubricating the auger
Using a grease gun, inject 2 to 3 shots of universal
grease into the grease nipple (
grease into the grease nipple (
40).