Jaguar 145 User Manual
12
ЗАПРАВКА НИЖНЕЙ НИТКИ
1. Поднимите иглу в крайнее верхнее
положение, поворачивая маховое
колесо на себя.
2. Для снятия крышки шпульного отсека
нажмите на левый угол пластины,
одновременно сдвигая клавишу
открывания вправо.
3. Вставьте шпульку, убедившись, что
шпулька врашается против часовой
стрелки.
4. Проденьте нитку через прорезь (А) и
заведите её влево.
Надавливая на шпульку, проденьте
нить через прорезь (В) до щелчка,
затем оставьте около 15 см нитки.
5. Установите крышку шпулечного отсека
на игольную пластину.
EINLEGEN DER SPULE UND
DES UNTERFADENS
1. Bringen Sie die Nadel in ihre höchste
Stellung, indem Sie das Handrad nach
vorn drehen.
2. Entfernen Sie die Spulenabdeckung.
3. Legen Sie die Spule so ein, dass sie sich
entgegen dem Uhrzeigersinn dreht.
4. Ziehen Sie den Faden durch den Schlitz
(A) und dann nach links.
Halten Sie die Spule leicht mit einem
Finger fest, und ziehen Sie den Faden
zum Schlitz (B), bis Sie ein leises
Klicken hören. Ziehen Sie dann etwa
15cm Faden aus der Spule heraus.
5. Setzen Sie die Spulenabdeckung
wieder ein.
THREADING THE BOBBIN
THREAD
1. Raise the needle to its highest position
by rotating the hand wheel towards
you.
2. Remove the bobbin cover plate.
3. Insert the bobbin making sure the
bobbin rotates counter-clockwise.
4. Pull thread through the slot (A) and
then to the left.
With a finger held gently on top of the
bobbin, pull thread through the slot
(B) until you hear a clicking sound,
and then leave about 6” (15 cm) of
thread.
5. Replace the bobbin cover plate onto
the needle plate.
B
A
②
⑤
④
①
③
A