Cisco Cisco Clean Access 3.5
4-43
Cisco Clean Access Manager Installation and Administration Guide
OL-7044-01
Chapter 4 Switch Management and Cisco Clean Access Out-of-Band (OOB)
Configure OOB Switch Management in the CAM
Figure 4-27
Advanced Config — Port Security
Note
•
Port Security can only be enabled on a port set to Access mode (i.e not Trunk mode).
•
The MAC address(es) connected to a particular port may not be available after Port Security is
enabled. This occurs on some models of Cisco switches (e.g. 4507R, IOS Version 12.2(18) EW).
enabled. This occurs on some models of Cisco switches (e.g. 4507R, IOS Version 12.2(18) EW).
•
If implementing High-Availability, ensure that Port Security is not enabled on the switch interfaces
to which the CAS and CAM are connected. This can interfere with CAS HA and DHCP delivery.
to which the CAS and CAM are connected. This can interfere with CAS HA and DHCP delivery.
Group
This page displays all the Group Profiles configured in the Clean Access Manager, and the Group
Profiles to which the switch currently belongs. You can add the switch to other Groups, or you can
remove the switch from a Group Joined. To changed the Group membership for all switches, go to
Switch Management > Profiles > Group (see
Profiles to which the switch currently belongs. You can add the switch to other Groups, or you can
remove the switch from a Group Joined. To changed the Group membership for all switches, go to
Switch Management > Profiles > Group (see
Figure 4-28
Config Group