Cisco Cisco Clean Access 3.5
6-25
Cisco Clean Access Manager Installation and Administration Guide
OL-7044-01
Chapter 6 User Management: Auth Servers
Test User Authentication
Test User Authentication
The Auth Test tab is intended to allow you to test Kerberos, RADIUS, Windows NT, and LDAP
authentication providers you configured against actual user credentials. It also shows the role assigned
to the user. When creating or making changes to an existing auth source, you can create a specific Auth
Server provider entry to point to a staging or development setup and use the Test feature to test the
changes.
authentication providers you configured against actual user credentials. It also shows the role assigned
to the user. When creating or making changes to an existing auth source, you can create a specific Auth
Server provider entry to point to a staging or development setup and use the Test feature to test the
changes.
To test authentication:
1.
From User Management > Auth Servers > Auth Test tab, select the provider against which you
want to test credentials in the Provider list. If the provider does not appear, make sure it is correctly
configured in the List of Servers tab.
want to test credentials in the Provider list. If the provider does not appear, make sure it is correctly
configured in the List of Servers tab.
2.
Type the username and password for the user and if needed a VLAN ID value.
3.
Click Authenticate. The test results appear at the bottom of the page.
Figure 6-22
Auth Test
Note
The Auth Test feature does not apply to S/Ident, Transparent 801.x, Transparent Windows, and Cisco
VPN Server authentication provider types.
VPN Server authentication provider types.