Cisco Cisco Mobile Wireless Transport Manager 6.1 Release Notes

This section describes caveats that exist in the MWTM 6.1.1 software.

CSCsg92892 

When provisioning ITP nodes from the Provision tab of the web interface, some provisioning 

operations might fail on the node with these symptoms and conditions:

None. The user must know the ITP card information and specify correct values in the 

provisioning request.

CSCsu02993 

Changing the media type for 
FastEthernet or 
GigabitEthernet interface

Invalid input detected

FastEthernet or GigabitEthernet on the node does not support 
the media type configuration option, but the user specified a 
media type in the MWTM provisioning request.

Changing speed for 
FastEthernet or 
GigabitEthernet interface

Invalid input detected

FastEthernet or GigabitEthernet on the node does not support 
the speed configuration option, but the user specified the speed 
in the MWTM provisioning request.

Configuring MTP3 User 
Adaptation (M3UA) or 
SCCP User Adaptation 
(SUA) offload, or Local Peer 
offload

Error: at least one 

address must reside on 

slot xx

The user specified an IP address that does not exist for the 
specified card slot.

Configuring M3UA or SUA 
offload, or Local Peer 
offload

Error: XXX is already 

offloaded to this 

linecard slot=xx

The user specified a target card slot that is already in use by 
another M3UA or SUA offload, or Local Peer offload.

The ITP does not allow mixed types between M3UA or 
SUA offload, and Local Peer offload. 

Configuring the line priority 
for the clock source line 
option on the Cisco 2600 
T1/E1 controller 

% Invalid input detected 

at '^' marker.

The '^' marker points to the 
line priority: primary or 
secondary.

While configuring the clock source line priority option on the 
T1/E1 controller, the user specified the primary or secondary 
option on the line, but the WAN Interface Card (WIC) card has 
only one port, and does not support the line priority option.

Configuring the secondary 
line priority for the clock 
source line option on the 
Cisco 7xxx ITP T1/E1 
controller

% Invalid input detected 

at '^' marker.

The '^' marker points to the 
secondary line priority: 
primary or secondary.

When configuring the clock source secondary line priority 
option on the T1/E1 controller, the user specified a number that 
is greater than the supported range on the device. Although the 
MWTM allows values 1-72, some cards only support 1-8 or 
1-16.