Cisco Cisco Expressway Installation Guide
Remotely Connect to Serial Using the CIMC
Note:
For remote access to the serial port, you must enable Serial over LAN (SoL) on the CIMC. You can do so under
Server > Remote Presence > Serial Over LAN in the CIMC interface.
1.
On your chosen emulator, connect using SSH and enter the CIMC IP address to connect.
2.
Enter admin and password as the default username and password and press Enter.
3.
Type
connect host
and press Enter.
4.
You are now connected using serial and will see the login prompt
cisco login:
You can now proceed to configure the Cisco Expressway.
Configure the Cisco Expressway
If the system has just booted up, the terminal emulator program on the PC will display the Cisco Expressway’s startup
information. After approximately four minutes you will get the login prompt. If the Cisco Expressway was already on
when you connected the serial cable, press
information. After approximately four minutes you will get the login prompt. If the Cisco Expressway was already on
when you connected the serial cable, press
Enter
to get the login prompt.
1.
Enter the username
admin
and press
Enter
.
2.
Enter the default password of
TANDBERG
and press
Enter
.
You will get the install wizard prompt:
Run install wizard [n]:
3.
Type
y
and press
Enter
.
4.
Follow the prompts given by the install wizard to specify the following:
—
The password you want to use for your admin account.
Note:
For security reasons you are advised to change the password from the default of
TANDBERG
.
—
Whether you want to use IPv4, IPv6 or Both .
—
The LAN 1 IP address of the Cisco Expressway.
—
The LAN 1 IPv4 subnet mask of the Cisco Expressway (if you have selected IPv4).
—
The IP address of the default gateway of the Cisco Expressway.
—
The Ethernet speed.
Note:
Use the default value of
Auto
.
—
Whether you want to use SSH to administer the Cisco Expressway.
5.
After the wizard is finished the following message will appear:
Setting other settings...OK.
The system must be restarted for new
settings to take effect..
settings to take effect..
You will get a restart prompt:
Restart Now?
Type
y
and press
Enter
.
6.
After it has rebooted, the Cisco Expressway is ready to use. You can access the Cisco Expressway's web
interface using the IP address assigned to the LAN 1 Ethernet port.
interface using the IP address assigned to the LAN 1 Ethernet port.
Note:
For security reasons you are advised to change the password for the
(if you have not
already done so) and the
from the default of TANDBERG.
13
Cisco Expressway CE1100 Appliance Installation Guide
Configure