Cisco Cisco Expressway
3. On the left hand side, select a line.
4. Set up the required directory number (for this example use a 3xxx number).
Configuring the SIP Trunk security profile
1. Go to
System > Security > SIP Trunk Security Profile
.
2. (Before version 9.x) Click Add New and name the new profile.
3. (9.x onwards) Select Non Secure SIP Trunk Profile.
4. Configure the fields as follows:
Name
Non Secure SIP Trunk Profile
Device Security Mode
Non Secure
Incoming Transport Type
TCP+UDP
Outgoing Transport Type
TCP
Incoming Port
5060
Accept Unsolicited Notification
Select this check box
Accept Replaces Header
Select this check box
5. Click Save.
Configuring the SIP Trunk device
1. On Unified CM, go to
Device > Trunk
.
2. Click Add New.
3. Select a Trunk Type of SIP Trunk.
l
Device Protocol displays SIP.
l
If asked for a Trunk Service Type, select None (Default).
4. Click Next.
5. Configure the
Device Information
fields as follows:
Device Name
As required, such as Expressway_system
Device Pool
(As set up in System > Device Pool)
Call classification
OnNet
Location
(As set up in System > Location)
Packet Capture Mode None
Media Termination
Point Required
Point Required
Clear this check box if any video phones registered to Unified CM are to make or
receive video calls with endpoints routed via Expressway.
receive video calls with endpoints routed via Expressway.
Select this check box if audio devices only are registered to Unified CM.
SRTP Allowed
Cisco Unified Communications Manager with Cisco Expressway (SIP Trunk) Deployment Guide (X8.6)
Page 8 of 37
Configuring Unified CM for an Expressway trunk