Cisco Cisco Expressway
Configuring the trunk to Expressway to specify a list of
Expressway peers
Expressway peers
1. On Unified CM, go to
Device > Trunk
.
2. Select the previously configured Trunk.
3. Scroll down and configure the
SIP Information
fields as follows:
(Click + to obtain additional destination address entries.)
Destination address is an SRV
Ensure that this check box is not selected
Destination address 1 and
Destination port 1
IP address or DNS name of Expressway peer 1
5060 or 5061 depending on connectivity (TCP/TLS)
Destination address 2 and
Destination port 2
IP address or DNS name of Expressway peer 2
5060 or 5061 depending on connectivity (TCP/TLS)
Destination address 3 and
Destination port 3
IP address or DNS name of Expressway peer 3 – if it exists
5060 or 5061 depending on connectivity (TCP/TLS)
... up to Destination address 6 and
Destination port 6
... repeat up to IP address or DNS name of Expressway peer 6 –
where they exist
where they exist
4. Click Save.
5. Click Reset.
6. Click Reset.
Cisco Unified Communications Manager with Cisco Expressway (SIP Trunk) Deployment Guide (X8.5.2)
Page 36 of 42
Appendix 2: Connecting Unified CM to an Expressway cluster