Cisco Cisco Expressway Maintenance Manual

Page of 473
CE Series Appliances
The Expressway is available as a dedicated CE Series appliance based on UCS hardware, as follows:
CE1100 appliance: a new platform introduced to fit the UCS M4 chassis. Based on a UCS C220 M4L, replaces the 
CE500 and CE1000. The CE1100 appliance operates as a medium capacity or large capacity Expressway, depending 
on whether you install 1 Gbps or 10 Gbps NICs.
Note: 
The CE500 and CE1000 platforms are no longer available to order. See 
See Cisco Expressway CE1100 Appliance Installation Guide on the 
.
Software Versions Supported by Hardware Platforms
Platform name
Serial Numbers
Scope of software version support
Small VM (OVA)
(Auto-generated)
X8.1 onwards
Medium VM (OVA)
(Auto-generated)
X8.1 onwards
Large VM (OVA)
(Auto-generated)
X8.1 onwards
CE500
 (Expressway pre-installed on 
UCS C220 M3L)
52C#####
X8.1.1 onwards
CE1000
 (Expressway pre-installed on 
UCS C220 M3L)
52B#####
X8.1.1 onwards
CE1100 (Expressway pre-installed on 
UCS C220 M4L)
52D#####
X8.6.1 onwards
Table 3    Expressway Software Versions Supported by Platform
† As of 26
th
 February 2016, you cannot order the CE500 and CE1000 appliances from Cisco. See the 
 for other important dates in the lifecycle of these platforms.
About This Guide
This guide  has been divided into several sections, providing conceptual, configuration and reference information 
about the various features and capabilities of the Expressway. It describes a fully equipped version of the 
Expressway. Your version may not have all the described extensions installed.
Most configuration tasks on the Expressway can be performed by using either the web interface or a command line 
interface (CLI). This guide mainly describes how to use the web interface. Some Expressway features are only 
available through the CLI and these are described as appropriate, including the relevant CLI command.
In this guide, instructions for performing a task using the web interface are shown in the format Menu > Submenu 
followed by the Name of the page that you will be taken to.
Where command line interface (CLI) commands are included, they are shown in the format:
xConfiguration <Element> <SubElement>
xCommand <Command>
Related Documentation
See 
 for a full list of documents and web sites referenced in this guide.
15
Cisco Expressway Administrator Guide
Introduction