Cisco Cisco Web Security Appliance S670 Troubleshooting Guide
ESA, SMA, and WSA Queries with the snmpwalk
Command Configuration Example
Command Configuration Example
Document ID: 117959
Contributed by Denis Jacobi, Cisco TAC Engineer.
Jul 16, 2014
Contents
Introduction
Prerequisites
Configure
ESA Configuration
SMA Configuration
WSA Configuration
Verify
Troubleshoot
Prerequisites
Configure
ESA Configuration
SMA Configuration
WSA Configuration
Verify
Troubleshoot
Introduction
This document describes how to use the snmpwalk command in order to query or poll the Cisco Email
Security Appliance (ESA), Cisco Content Security Management Appliance (SMA), or Cisco Web Security
Appliance (WSA).
Security Appliance (ESA), Cisco Content Security Management Appliance (SMA), or Cisco Web Security
Appliance (WSA).
Prerequisites
The infomation in this document is based on these software and hardware versions:
ESA with AsyncOS 5.x or later
•
SMA with AsyncOS 5.x or later
•
WSA with AsyncOS 5.x or later
•
A separate Linux or Unix host machine with the distribution net−snmp package installed is required
•
Note: This document references software that is not maintained or supported by Cisco. The information is
provided as a courtesy for your convenience. For further assistance, contact the software vendor.
provided as a courtesy for your convenience. For further assistance, contact the software vendor.
Configure
This section covers the configurations for the ESA, SMA, and WSA.
ESA Configuration
Enter the snmpconfig CLI command in order to ensure that Simple Network Management Protocol
(SNMP) is enabled.
(SNMP) is enabled.
1.
Download all related AsyncOS MIB files from the Cisco Email Security Appliance under Related
Tools:
Tools:
2.