Cisco Cisco Expressway Maintenance Manual
Expressway-C
Expressway-E
Location
section
Peer 1 address
Enter the FQDN of the Expressway-
E.
E.
Note that if you use an IP address
(not recommended), that address
must be present in the Expressway-
E server certificate.
(not recommended), that address
must be present in the Expressway-
E server certificate.
Not applicable
Peer 2...6 address
Enter the FQDNs of additional peers
if it is a cluster of Expressway-Es.
if it is a cluster of Expressway-Es.
Not applicable
Note that you should enable Unified Communications services on one traversal zone only per
Expressway.
Expressway.
4. Click Create zone.
Checking the status of Unified Communications services
You can check the status of the unified communications services on both Expressway-C and Expressway-
E.
E.
1. Go to
Status > Unified Communications
.
2. Review the list and status of domains, zones and (Expressway-C only) Unified CM and IM&P servers.
Any configuration errors will be listed along with links to the relevant configuration page from where you
can address the issue.
can address the issue.
Additional configuration
Configuring the HTTP server allow list (whitelist) on Expressway-C
Jabber client endpoints may need to access additional web services inside the enterprise. This requires an
"allow list" of servers to be configured to which the Expressway will grant access for HTTP traffic originating
from outside the enterprise.
"allow list" of servers to be configured to which the Expressway will grant access for HTTP traffic originating
from outside the enterprise.
The features and services that may be required, and would need whitelisting, include:
n
Visual Voicemail
n
Jabber Update Server
Cisco Expressway Administrator Guide (X8.1.1)
Page 62 of 343
Unified Communications
Configuring mobile and remote access on Expressway