Cisco Cisco ScanSafe Wi-Fi Hotspot Security Technical Manual
Contents
Introduction
Prerequisites
Requirements
Components used
Background Information
Configure
Anyconnect WebSecurity deployment through ASA
Verify
Upgrade/Downgrade Anyconnect version
Troubleshoot
Introduction
This document describes the deploying of AnyConnect web security module for client based VPN
terminating on Cisco Adaptive Security Appliances (ASA).
terminating on Cisco Adaptive Security Appliances (ASA).
Prerequisites
Requirements
There are no specific requirements for this document.
Components used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
Background Information
Upload the Anyconnect (recommend v4.1+) image on ASA
●
Enable the VPN profile on ASA, as shown in the image
●
Configure
Anyconnect WebSecurity deployment through ASA