Cisco Cisco Expressway
Reroute Incoming Request to
new Trunk based on
new Trunk based on
Never
4.
Click Save.
Configuring the Region with an Appropriate Session Bit Rate for Video Calls
Ensure that your regions have an appropriate session bit rate for video calls:
1.
Go to System > Region Information > Region.
2.
Select the region (for example the Default region).
3.
Set Maximum Session Bit Rate for Video Calls to a suitable upper limit for your system, for example 6000
kbps.
kbps.
4.
Click Save and then click Apply Config.
Configuring the SIP Profile for Phone Devices
This creates the SIP Profile that is to be applied to all phone devices.
1.
On Unified CM, go to Device > Device Settings > SIP Profile.
2.
Click Copy against the Standard SIP Profile.
3.
Configure the following fields, leaving everything else as its default value:
Name
Standard SIP Profile – for phone devices
Use Fully Qualified Domain in SIP
Requests
Select the check box
Allow Presentation Sharing using
BFCP
BFCP
Select the check box if BFCP (Dual video / presentation sharing) is
required.
required.
4.
Click Save.
Adding a Phone Device
1.
Go to Device > Phone.
2.
Click Add New.
3.
Select a SIP Profile of Standard SIP Profile – for phone devices.
4.
Configure the other fields as required.
5.
Click Save and click OK.
6.
Click Apply Config and click OK.
Alternatively, if there is already another phone configured, copy its configuration by selecting “super copy”, entering
the new phone’s MAC address and then changing the description (especially correct the MAC address part of the
description).
the new phone’s MAC address and then changing the description (especially correct the MAC address part of the
description).
Configuring the Device Directory Number
1.
Go to Device > Phone.
2.
Select the relevant device name.
10
Cisco Expressway SIP Trunk to Unified CM Deployment Guide
Configuring Unified CM for an Expressway Trunk