Cisco Cisco Web Security Appliance S670 Information Guide
Specify Interface for Authentication Traffic on the
Web Security Appliance
Web Security Appliance
Document ID: 118278
Contributed by Anuritha Konjety and Jai Koolwal, Cisco TAC
Engineers.
Aug 12, 2014
Engineers.
Aug 12, 2014
Contents
Question
Environment
Symptoms
Solution
Environment
Symptoms
Solution
Question
How do you configure the Cisco Web Security Appliance to use a specific interface for authentication traffic?
Environment
AsyncOS 7.x and later.
Symptoms
By default, the Cisco WSA will always use the Management interface for routing authentication traffic.
Solution
We can change this behavior by configuring a static route in the routing table and then specify the appropriate
interface we want to use for routing.
interface we want to use for routing.
Under the GUI >Network> Routes.
1.
Click Add Route.
2.
Under Destination, specify the Active Directory server IP address.
3.
Under the gateway section, specify the appropriate Interface gateway.
4.
Submit and commit the changes.
5.
Updated: Aug 12, 2014
Document ID: 118278