Cisco Cisco Expressway
3.
(9.x onwards) Select Non Secure SIP Trunk Profile.
4.
Configure the fields as follows:
Name
Non Secure SIP Trunk Profile
Device Security Mode
Non Secure
Incoming Transport Type
TCP+UDP
Outgoing Transport Type
TCP
Incoming Port
5060
Accept Unsolicited Notification
Select this check box
Accept Replaces Header
Select this check box
5.
Click Save.
Configuring the SIP Trunk Device
1.
On Unified CM, go to Device > Trunk.
2.
Click Add New.
3.
Select a Trunk Type of
SIP Trunk.
—
Device Protocol displays
SIP.
—
If asked for a Trunk Service Type, select
None (Default).
4.
Click Next.
5.
Configure the Device Information fields as follows:
Device Name
As required, such as Expressway_system
Device Pool
(As set up in System > Device Pool)
Call classification
OnNet
Location
(As set up in System > Location)
Packet Capture Mode
None
Media Termination
Point Required
Point Required
Clear this check box if any video phones registered to Unified CM are to make or
receive video calls with endpoints routed via Expressway.
receive video calls with endpoints routed via Expressway.
Select this check box if audio devices only are registered to Unified CM.
SRTP Allowed
Run On All Active
Unified CM Nodes
Unified CM Nodes
Select this check box
9
Cisco Expressway SIP Trunk to Unified CM Deployment Guide