Cisco Cisco Expressway Installation Guide
Configuring the VM guest (vSphere clients)
1. Select the VM guest and then select the
Console
tab.
The VM guest will take some time to boot, create its second hard disk partition and then reboot to a login
prompt.
You can ignore any RELEASE KEY INVALID messages that may appear.
prompt.
You can ignore any RELEASE KEY INVALID messages that may appear.
2. At the login prompt enter 'admin' for the username and 'TANDBERG' for the password.
3. At the Install Wizard prompt type y and then press Enter.
4. Follow the Install Wizard to enter the network IP information for the Expressway. (Defaults can be
entered by pressing Enter at the prompt.)
5. When the wizard completes, the configuration is applied and the Expressway logs you out.
Cisco Expressway on Virtual Machine Installation Guide (X8.2)
Page 11 of 30
Installing a VM