Cisco Cisco IGX 8400 Modules Troubleshooting Guide

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Hardware Error Summary
 Card Errors Example
 Related Information

Cisco WAN switching cards and modules log error codes when an anomaly occurs. Switch card errors are
indicated to the user by a "CD" symbol at the bottom of the switch command line interface (CLI) screen. If
you issue the dspcderrors command, a list of errors is displayed. These errors are presented based on access
level.

This list is a reference for IPX Network Trunk Card (NTC) hardware errors presented up to the StrataCom
level. StrataCom−level errors are service−significant only. Some users do not see all of the errors listed.

These are the hardware error codes that can occur on the NTC on an IPX or on the Network Trunk Modules
(NTM and NTM−B) on an IGX when you issue the dspcderrs<slot> command.

There are no specific requirements for this document.

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Solution ID : 1397

Description   : 22−Aug−96 FHA Updates added from NTM−B