Manualsbrain.com
  1. Manuals
  2. Brands
  3. Cisco
  4. Cisco 1900 2900 3900 Series 8-Port Gigabit Ethernet HS-WIC with PoE
  5. Data Sheet

Cisco Cisco 1900 2900 3900 Series 8-Port Gigabit Ethernet HS-WIC with PoE Data Sheet

Download
Page of 7
 
 
© 2011-2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 2 of 7 
Figure 1.    Cisco Multimode Four-Pair G.SHDSL EHWIC (EHWIC-4SHDSL-EA) 
 
Feature Summary 
● 
Complies with standard based on ITU Recommendation G.991.2 
● 
Supports G.SHDSL Annexes A (U.S. signaling) and B (European signaling) 
● 
Supports Annexes F and G 
● 
Offers symmetrical WAN speeds up to 1 x 2304 kbps over single copper pair, up to 2 x 2304 kbps over two 
copper pairs, up to 3 x 2304 kbps over three copper pairs, and up to 4 x 2304 kbps over four copper pairs 
using ITU-T G.991.2 Annexes A and B 
● 
Offers symmetrical WAN speeds up to 1 x 5696 kbps over single copper pair, up to 2 x 5696 kbps over two 
copper pairs, up to 3 x 5696 kbps over three copper pairs, and up to 4 x 56964 kbps over four copper pairs 
using ITU-T G.991.2 Annexes F and G 
● 
Supports EFM bonding; supports up to four SHDSL pairs bonding 
● 
In ATM mode, supports maximum of eight permanent virtual circuits (PVCs) 
● 
Supports dying gasp and wetting current 
● 
Supports point-to-point configuration 
● 
Supports 802.1Q, QinQ, trunk, and VLAN tagging 
● 
Supports ATM class-of-service (CoS) and IP quality-of-service (QoS) features, 802.1P, and differentiated 
services code point (DSCP) 
● 
Supports EFM (IEEE 802.3ah) operation, administration, and maintenance (OA&M) 
● 
Offers ability to configure multiple G.SHDSL EFM EHWICs per Cisco 1921, 1941, and 2900 and 3900 
Series Routers 
● 
Provides single RJ-45 connector system requirements 
System Requirements 
● 
The multimode four-pair G.SHDSL EHWICs are supported on all modular Cisco ISR G2 routers: 
Cisco, 1921, 1941, 2901, 2911, 2921, 2951, 3925, 3945, 3925e, and 3945e. 
● 
The multimode four-pair G.SHDSL EHWICs are supported in all Cisco IOS
®
 Software feature sets. 
● 
The routers listed previously need to run Cisco IOS Software Release 15.2(2)T or later. 
● 
The system requires no additional flash or DRAM memory other than the specified minimum memory for the 
previously mentioned Cisco IOS Software releases. 
● 
The multimode four-pair G.SHDSL EHWICs can be inserted into any EHWIC slot in any ISR G2 router.