Cisco Cisco Nexus 7000 Series Network Analysis Module (NAM-NX1) Installation Guide

Cisco Nexus 7000 Series Network Analysis Module (NAM-NX1) Quick Start Guide

OL-27548-01

Using the CLI Helper Utility for System Administrative Tasks

Step 1

Shut down the module using the CLI out-of-service module module_number to ensure a graceful
shutdown. Wait until the lights go off and unplug it.

Step 2

Carefully remove the NAM module out of the switch slot.

Step 3

To remove old memory DIMMs, push down on the white latches. All size DIMMs are uncovered, not
screwed in, and not soldered, and there is no other component blocking them, so they can be easily
removed.

Step 4

Follow all necessary antistatic standards in handling the hard disk drives.

Step 5

If a hard drive is already installed, you can remove it by unfastening the four screws that attach it to the
drive tray with a Number 2 Phillips screwdriver.

Step 6

Install the new DIMMs or hard drive. Avoid extra force when removing and inserting DIMMs.

Step 7

Plug the module back into the slot. You would see the STATUS button go red, and then green when it is
booting up.

Using the CLI Helper Utility for System Administrative Tasks

You can use the CLI helper utility to perform the following administrative tasks:

•

Configuring Network Parameters, page 25

•

Downloading an Application Image and Writing to HDD, page 26

•

Downloading an Application Image and Reformatting the HDD, page 26